The height of the section, wicket and gate is calculated from the ground to the top of the section,
provided that the distance between the ground and the bottom edge is up to 10 cm.
plastic grill
The length of the lattice for the fence - 1890 mm,
Height - 985 mm (for a fence 1200 mm high).
Lath width 38 mm.
The cell is square 50x50 mm.
The grid is inserted into the upper and lower crossbars,
which in turn are inserted into the holes in the pillars
crossbeams
Upper and lower. They have the same dimensions.
height 89 mm,
width 51 mm,
length 2385mm
Only the bottom bar is reinforced
aluminum profile.
The length of the grate is 1974mm, so you can adjust the length of the fence section, leaving a gap between the grate and the post.
Mounting profile
2 pcs U-shaped PVC profile -
this is a kind of stub that
attached to the edges of the lattice,
adjacent to the pillars
pillars
Pole sizes:
- 102x102x1850 mm.
The thickness of the walls of the columns is 3.8 mm.
705 mm - the size from the bottom edge of the post to the bottom edge of the hole (important for concreting)
intermediate posts
with two holes
on one line
Final pillars
with one hole
corner posts
with two holes
angled
Reinforced poles
with aluminum profile
inside the post
"English" stub
Assembling a plastic fence from components and installation steps :
- Territory marking.
- Dig holes for the posts, using the length along the axes of the posts.
- Concreting of the first column.
- Installation of the second pillar, but do not temporarily concrete it.
- Installation of the lower crossbar (with aluminum profile) into the grooves on the posts. When the crossbar entered the groove and snapped into place, it will no longer be possible to remove it back.
- Connection of the U-shaped fixing profile with the ends of the grille.
- Installation of the grate in the lower crossbar.
- The upper crossbar is put on the grate.
- The top bar is connected to the pole. When the crossbar entered the groove and snapped into place, it will no longer be possible to remove it back.
- Concreting of the second column.
- Repeat the operation with the following pillars and panels according to P. 4-10. before installing all pillars and sections.
- After installing the entire fence, glue the covers (plugs) on the posts.
General view before installation
U-shaped bar is put on the grate
Grille with U-bar inserted
into the grooves of the lower and upper crossbars
The crossbars snap into the poles.
The latch is on the crossbar and if it clicks,
the crossbar cannot be pulled back.
Type of fence "assembly". But without fixing the crossbars in the holes of the pillars.
We import plastic gates and gates ourselves, so the price will be the lowest in Ukraine. Metal gates and wickets are produced under our Kazachka trademark, so the price will also be acceptable.
