Egoza mounting bracket

Price of brackets for mounting egoza ➤

Kazachka's staples are staples for the installation of barbed obstacles , metal strips stamped from a galvanized sheet with dovetail ends. The dovetail allows you to make a connection in the form of a ring, which is very difficult to pry with a screwdriver to disconnect.

Technical characteristics of the Cossack bracket for mounting the egoza

With a bracket

• connect together the spirals of two coils of egoza in length or 2-3 parallel helixes of egoza;
• attaching the egoza to the tension wire, which can be used as Halberd barbed wire, ordinary single-core barbed wire, spring wire, low-carbon galvanized wire, low-carbon polymer-coated wire;
• connect the coils of egoza to each other;
• interconnect bundles of electrical wires.

Prior to the appearance on the Ukrainian market of Kazachka egoza, almost all Ukrainian manufacturers connected the turns of the barbed cutting spiral with tape or wire twists or a bracket made of galvanized low-carbon wire.

it was cheap, but these staples did not justify themselves, because. they could easily be bitten or pried open with a screwdriver.
Thus, the whole point of installing a fidget security barrier was lost. After all, because of one detail, the entire barrier significantly lost its protective functions.
Therefore, the presence of a flat bracket on Kazachka's egoza led to a sharp increase in sales of a relatively new product, and in a short time Kazachka's egoza occupied about 30% of the market for barbed obstacles.
This success led to the fact that almost all Ukrainian manufacturers replaced the inefficient round wire clip on their fences with flat galvanized clips.

Such a bracket cannot be eaten with pliers or a rebar cutter.
It is extremely difficult to open the bracket for the egoza from the sheet with a screwdriver even if the egoza is in the folded state.
It is impossible to do this at altitude.

If earlier an intruder, having a pocket knife and a certain amount of time in reserve, could unbend a wire clip for a fidget and get into a guarded object, now this category of citizens has been eliminated.
Today, to get through the egoza, one pocket knife is not enough.

If you are going to install a fidget, then we recommend purchasing staples as well, because. there will be a need to connect the extreme turns of the egoza with each other and fasten the egoza to the tension wire.
In this case, the prickly cutting barrier will fully serve for years and fulfill its security function.
You can also buy brackets for egoza from us for installation of egoza . As a tension wire, we buy Halberd barbed wire, single-base barbed wire , polymer- coated wire, galvanized wire with a diameter of 3 mm.

Always up-to-date egoza price (download price)