Plaster reinforcement, reinforcement of heat-insulating pipes, production of cages - this is a small part of what can be done using the Rabitsa 35 / 1.8 mesh.
Chain-link mesh 35x35 is a woven mesh with a mesh size of 35 mm made of low-carbon wire with a diameter of 1.8 mm.
Tolerances for the chain-link mesh 35x35 are provided by GOST 5336-80 and are equal to:
- the size of the positive cell is not more than 3.5 mm;
- the maximum tolerance for the width of the grid is 39.2 mm.
The OK wire diameter tolerance can be no more than -0.1 mm.
Always pay attention to the weight of the mesh Chain-link 35x35.
Due to mesh tolerances, the weight of two mesh rolls may not match. But the difference in the mesh weight from the theoretical one by more than 30% is no longer the norm. You can be deceived with wire diameter or mesh size.
The weight of 1m 2 of the chain-link grid 35x35 is 1.29 kg.
Grid Chain-link 35x35 is made of low-carbon OK wire . The wire can be galvanized to extend the service life of the mesh Chain-link 35x35, as well as uncoated.
On galvanized wire with a diameter of 1.8 mm, the specific gravity of zinc on the surface must be at least 50 g/m 2 . Under normal conditions, a grid with such a coating will last at least 7 years before rust appears.
The grid the Chain-link 35х35 is delivered in rolls. The height of the roll can be up to 4 meters, but such a grid is made to order. The price of the mesh Chain-link 35x35x1.8 depends on the volume of the order.
Most often, the chain-link mesh 35x35x is supplied in rolls:
- height 1.5 m;
- length up to 10 linear meters.
Rolls of mesh Rabitsa 35x35 are packed with paper, burlap or polymer film, and also tied with knitting wire to prevent roll unwinding.
Cheap or temporary fences are made from the Rabitsa 35x35x1.8 mesh , but this mesh is not strong enough and may not withstand heavy loads. Cheaper than the chain-link mesh, only the Cossack mesh is lightweight , which is well suited for fencing large areas.