The grid the Chain- link 25х25 is made in accordance with GOST 5336-80.
Like any metal mesh, the chain-link mesh 25x25 has its own tolerances prescribed in GOST:
- on the width of the grid 25x25 tolerance - 28 mm;
- positive cell tolerance is not more than 2.5 mm.
Tolerance for wire diameter according to GOST 3282-74 for wire with a diameter of 2.2 mm is not more than -0.1 mm.
Wire for the manufacture of mesh Chain-link 25x25x2.2 can be galvanized and uncoated. The density of zinc on the surface of the wire according to GOST 3282-74 must be at least 60 g/m 2 .
The grid the Chain- link 25х25 is delivered in rolls.
To order, you can make a mesh Rabitsa 25x25x2.2 up to 4 m high.
The standard roll size has the following parameters:
- roll height 1.5 meters;
- length 10 linear meters.
Rolls of mesh Chain-link 25x25 are tied in the middle with low-carbon wire , wrapped around the edges with burlap, thick paper or polymer film.
The theoretical weight of 1 m 2 of 25x25 woven mesh is 2.69 kg. The price of the mesh Chain-link 25x25x2.2 depends on the volume of the order.
The use of the mesh Chain-link 25x25 is quite wide: this includes plaster reinforcement and the installation of fences, reinforcement of heat-insulating pipes, the manufacture of cages, partitions, and much more.
For fencing large areas, using a 25x25 Rabitsa mesh is quite expensive, because there is a lot of metal in Rabitsa with such dimensions. A cheap fence will turn out from the Cossack lightweight grid .