To install a fence made of lightweight mesh TM Kazachka , first, we will install a post at the corner of the territory. To do this, we can drive it half a meter into the ground with a sledgehammer, we can dig a hole 20-30 cm deep and drive a column into the ground another 30 cm, and pour concrete mortar into the hole. A more serious strengthening of the fence post is not required. We support the fence post along the direction of the fence with two inclined posts, which we also dig into the ground.
We tie the canvas of the lightweight TM Cossack mesh to the post. To do this, we can make hooks on the fence post from hammered nails or welded wires.
We stretch the canvas of the lightweight TM Cossack mesh for 50 m and drive in the next column at the end of the canvas. This fence post must also be reinforced on both sides with inclined posts. The tension of the wires of the base of the fence will occur as follows: we pass the wire through the fastening ring and pull it in the opposite direction using ordinary pliers. Then we twist the free end of the wire with itself, forming a strong knot. We do this with each warp wire. You can also use other methods of stretching the fabric of the Kazachka lightweight mesh, for example, tie all the wires of the mesh base to the vertical reinforcement (strip) and already stretch the reinforcement (strip) with threaded hooks and screw (tie, weld, nail) to the fence post.
Scheme of tensioning the fence from the mesh Cossacks lightweight. (with magnification)
We attach the next roll of the Cossack lightweight mesh to the same post and continue to mount the fence. We will fill the gap of 50 m between the resistant posts of the lightweight Cossack fence after 4-5 meters with pillars, the purpose of which is to prevent the horizontal movement of the lightweight Cossack fence. Some of these poles can be reinforced with inclined poles set perpendicular to the direction of the fence.
Consumers often doubt: a lightweight Cossack fence cannot withstand the pressure of a large animal, such as a wild boar.
To do this, an electric shepherd's wire is attached to the fence on insulators. A weak current does not harm animals, but scares them away from overcoming the fence.
In order for the mesh fence to be seen by animals, thick branches or boards are called in the center of the fence.
Installation of a fence made of lightweight mesh TM Kazachka