GOST 4028-63

⇦⇦⇦ Price in the price list. The specifications for nails are described below.

STATE STANDARD OF THE UNION OF THE SSR

CONSTRUCTION NAILS

CONSTRUCTION AND DIMENSIONS

GOST 4028-63

USSR STATE COMMITTEE FOR PRODUCT QUALITY MANAGEMENT AND STANDARDS

Moscow

STATE STANDARD OF THE UNION OF THE SSR

Date of introduction of GOST 4028-63 from 08/01/64

Non-compliance with GOST 4028-63 is punishable by law

1. The design and dimensions of construction nails with a flat head must comply with those indicated in the drawing. 1 and in table. one.

Heck. one.

Table 1, mm

Symbol for flat head nails with a shaft diameter of 1.2 mm and a length of 25 mm:

Nails P 1.2×25 GOST 4028-63

(Revised edition, Rev. No. 2).

2. The design and dimensions of construction nails with a conical head must comply with those indicated in Fig. 2, 3, 4 and in the table. 2.

Round nails

Heck. 2.

Club nails

Heck. 3.

Club nails with lintels

Heck. 4.

table 2

mm

Note. At the request of the consumer, round nails with a size of 1.8 × 32 are produced with a flat head.

Conventional designation of nails with a conical head, round with a diameter of 2.5 mm, 60 mm long:

Nails K 2.5×60 GOST 4028-63

The same, clubs:

Nails T 2.5×60 GOST 4028-63

The same, clubs with jumpers:

Nails TP 2.5×60 GOST 4028-63

(Changed edition, Rev. No. 1, 2).

3. Technical requirements for nails - according to GOST 283-75.

Note. One-sided uniform deflection of the rod in the middle part of the 1.8 × 60 nail should not exceed 0.7 mm.

(Changed edition, Rev. No. 1, 2).

4. Theoretical weight of nails is indicated in the reference appendix.

(Introduced additionally. Amendment No. 2).

APPENDIX

Reference

Theoretical mass of nails

Note. The mass of 1000 club nails is 15% less, and that of club nails with lintels is 12% less than the mass of 1000 round nails of the same size.

(Changed edition, Rev. No. 1, 2, 3).